KL16377
Looking for a hopper to fit your shiny new MaltZilla? Look no further!
The MaltZilla Aluminium Hopper is made from high quality aluminium, so it won't rust or break.
The clever design has all of the assembly bolts on the outside of the hopper, so there is nothing to impede the flow of the malt as you mill.
There is a built in aluminium finger guard/chute cover.
This high quality hopper will hold up to 7kg of grain - no more slowly adding your grain as you mill, because this beauty can hold the entire grain bill!*
The MaltZilla Aluminium Hopper comes flat packed, so will require assembly. Included in the box are all the bolts needed to assemble the hopper and mount on the MaltZilla.
The hopper is suitable to be mounted on the MaltZilla in both over and under bench configurations, and is also compatible with the MaltZilla Mounting Board.
*Based on an average grain bill for a 35L BrewZilla.
Overall rating: 4.571429 / 5 from 7 reviews.
Review topics: [].
"Work great with the Maltzilla. No instructions but most should be able to work it out. Small nuts and bolts. I kept the side bolts loose then mounted to the top, moved into position and tighten. Don't over tighten the 4 base bolts as the slide needs to move."
"Used a plastic cutting board to make a transition device"
"Fits the whole Grain bill for the Gen4. 1 35lt, was a little bit fiddly to put together flush, and I had to file the little slide piece just a touch, but it looks quality and does the job"
"Works well easy to put together."
"Fits together ok and works as it should. Probably better with larger grains as there are gaps where the panels don't quite fit together and around the base /slider where small grains (I'm milling linseed and millet) and meal fall out. I taped the side seams ok but can't do anything about the base."
"The hopper is much easier to clean than a water bottle would be. Mine was missing one nut, but it works fine without it"
"Good hopper"
